| Voltage Type |
Charge Pump |
| Vout (Max) (V) |
6.3 |
| SRAM (kB) |
4 |
| Istandby (μA) |
3 |
| IO Level (V) |
1.8<br>3.3 |
| AAE |
YES |
| Input Signal |
IIC<br>1TRIG |
| LRA Calibration |
LCC2.0 |
| Temperature |
-40℃~85℃ |
| TikTap |
YES |
| Package (mm) |
FCQFN 2X2-16L |
•1MHz I2C Bus
•4-KByte Memory
•12k/24k/48k input wave sampling rate
•F0 detect and tracking
•Advance autobrake engine integrated
•Playback mode:
➢Real time playback(Up to 4KByte FIFO)
➢Memory playback
➢1 Trigger playback
➢One wire playback
➢Cont playback
•Resistance-Based LRA Diagnostics
•Drive signal monitor for LRA protect
•Drive Compensation Over Battery Discharge
•Fast Start Up Time ＜1ms
•Dedicated interrupt output pin
•Charge pump output voltage up to 6.3V
•Minimum load resistance 10Ω
•Support automatically switch to standby mode
•Standby current：3uA@Vbat=3.6V
•Shutdown current：0.1uA
•Supply voltage range 3 to 5.5V
•Short-Circuit Protection, Over-Temperature Protection, Under-Voltage Protection
•FCQFN 2mm × 2mm × 0.55mm -16L Package
•Support Tik Tap haptic game solution for
Gamepad/AR/VR/MR.
AW86715G is a high voltage H-bridge, single chip LRA haptic driver, with F0 detecting and tracking based on BEMF, with a charge pump up to 6.3V drive voltage inside, supporting real time playback, memory playback, cont playback, one wire playback and hardware pin trigged playback. A typical startup time of 1ms makes the AW86715G an ideal haptic driver for fast responses.
AW86715G integrates a 4KByte SRAM for user-defined waveforms to achieve a variety of vibration experiences, supporting 3 sampling rate(12k/24k/48k) of waveforms loaded in SRAM, supporting output waveform sampling rate up-sampling to 48k.
AW86715G integrates an autobrake engine to suppress the aftershocks to zero for different drive waveforms(short in long) on different LRA motor.
AW86715G supports LRA fault diagnostic based on resistance measurement and protections of short-circuit, over-temperature and under-voltage.
AW86715G integrates a high-efficiency charge pump as the H-Bridge driver supply rail. The output voltage, maximum current limit and maximum charge pump current are configurable.
AW86715G features configurable automatically switch to standby mode after haptic waveform playback finished. This can less quiescent power consumption. The RSTN pin provides further power saving by fully shut down the whole device. Dedicated interrupt output pin can detect real time FIFO status and the error status of the chip.
AW86715G features general settings are communicated via an I2C-bus interface and its I2C address is configurable.
AW86715G is available in a FCQFN 2mm × 2mm × 0.55mm -16L package.
