| Actuator Type |
CL AF |
| Output I(mA) |
±150 |
| VDD (Min) (V) |
2.6 |
| VDD (Max) (V) |
3.6 |
| I2C (Hz) |
400K<br>1M |
| I2C Addr |
Configurable（256） |
| IQ (mA) |
4.3 |
| ISD (μA) |
6 |
| DAC (Bit) |
12 |
| Temperature |
-40℃~85℃ |
| Control Mode |
CL PID |
| Package (mm) |
WLCSP 1.69X0.86-6B |
2.6V to 3.6V power supply
Low quiescent current
2-wire serial interface(I2C)
- Support broadcast
Built-in constant current driver
- ±150mA current
- 12-bit DAC
Built-in hall sensor
- Si hall sensor
- 11-level hall sensor signal amplification
Built-in 12bit A/D converter
- 4 input channels
Built-in D/A converter
- 10-bit for hall offset
- 8-bit for constant current bias
Built-in Flash memory
- Flash 2K bytes (64byte/page)
Built-in PID controller
- PID coefficients can be specified by I2C
- Filter coefficients can be specified by I2C
- Support multi-scenes application
Package
- WLCSP 1.690mm x 0.860mm x 0.265mm-6B Package
AW86020 is a Bi-directional voice coil motor close loop driver chip, which integrated a constant current driver. The maximum output current is ±150mA. The supply voltage range is from 2.6V to 3.6V.
AW86020 is controlled through the I2C serial interface, and its operating frequency can reach up to 1MHz. The I2C device address can be configured by Flash, The default address is 0xD4 (7-bit 0x6A).
AW86020 integrated hall sensor. The hall sensor contains temperature correction algorithm and offset cancel circuit.
AW86020 supports 17-points and 33-points linearization calibration algorithm. X-axis and Y-axis index points are stored in Flash when 17-points algorithm is enabled, only Y-axis index points are stored when 33-points algorithm is enabled.
AW86020 integrated PID controller and digital filter circuit, the coefficients of PID and filter circuit are float point. These coefficients can be configured in two ways: 1) automatically loaded (Auto-load), 2) I2C configuration.
AW86020 contains Flash and Cache. Flash storage area size is 2K bytes and it can form fully mapping with Cache.
