| DC_CC(V) |
|
| PD Specification |
|
| DC_VBUS(V) |
|
| Power Role |
|
| IO Level (V) |
|
| Package (mm) |
FCQFN 1.2X1.2-9L |
USB-IF PD 3.1 certified (TID #8339)
Certified by IEC-62680-1-2 and IEC-62680-1-3
Built-in software LPD
Dual-role functionality with autonomous DRP toggle
Attach/Detach detection as either a host or a device based on what has been attached
Operate as dedicated host, dedicated device or DRP by host software configuration
Support USB-PD 3.1 SPR and 28V EPR Mode
Integrate the several functionality of the CC Pins according to Type-C 2.4
VBUS detection and discharge control
Dead Battery Support (SNK mode support when no power applied)
Support wake detection avoids CC voltage toggle to prevent electric corrosion
BIST mode supported
FCQFN 1.2 mm × 1.2 mm-9L package
The AW35615 enables the USB Type-C detection including attach and orientation by autonomous DRP toggle. The CC logic block monitors the CC1/CC2 pin for pull-up or pull-down resistances to determine when a USB port has been attached, the orientation of the cable and the role detected. Furthermore, AW35615 supports wake detection without CC voltage toggle, which brings lower power and avoids electric corrosion due to voltage toggle.
The AW35615 integrates the physical layer of the USB BMC Power Delivery protocol to allow up to 140W of power and role swap. The BMC PD block enables full support for alternative interfaces of the Type-C specification.
The AW35615 supports VBUS voltage detection and discharge control by the discharge resistance integrated in VBUS channel. The withstand voltage value of CC pins is up to 28V.