AW8646GQNR

AW8646G Dual H-Bridge Stepper Motor Driver

参考价格
  • 1-99¥11.54
  • 100-249¥9.46
  • 250-499¥7.61
  • 500-999¥6.00
  • 1000+¥4.61

产品详细信息

参数

Motor Type Stepper Motor
H bridge 2
Micro Step 1/32
VDD (Min) (V) 3
VDD (Max) (V) 12
Peak Current (A) 1.4
Ron (mΩ) 730
Control Mode STEP/DIR
CTRL IF HW GPIO
Temperature -40℃~105℃
Function Current Regulation nFault status
Package (mm) QFN 4X4-24L

封装 | 引脚 | 尺寸

QFN 4X4-24L

特性

3V to 12V Supply Voltage Range 1.4A Full Scale current per H-Bridge Rdson HS + LS: Typical 0.73Ω Support up to 1/32th Microstepping Decay Modes supported: Adaptive Decay Technology Mixed Decay Slow Decay Fast Decay Support 1.8V Logic Level Programmable off-time 10,20, or 30s off-time Programmable Motor Torque Current Short-Circuit Protection, Over-Temperature Protection, Under-Voltage Protection Fault Condition Indication QFN 4mm X4mm X0.85mm-24L package

说明

The AW8646G is a flexible microstepping stepper motor driver. It is designed to operate bipolar stepper motor with up to 1/32th step mode for mobile phones, tablets, and other automated equipment applications. The device can be controlled by simple STEP/DIR interface allowing easy interfacing to controller circuits. The output block of each H-bridge driver consists of N-channel and P-channel power MOSFETS configured as full H-bridges to drive the motor windings. Pins allow configuration of the motor in full-step up to 1/32th step modes. Decay mode is configurable so that adaptive decay, slow decay, fast decay, and mixed decay can be used. A low power sleep mode is provided to achieve very-low quiescent current draw. AW8646G is capable of driving up to 1.4A (Full Scale) or 1A (RMS) current per H-Bridge The device offers a complete set of protection features including UVLO, overcurrent protection, short circuit protection, and over temperature. Fault conditions are indicated via the nFAULT pin

技术文档

类型
项目标题
语言
日期
产品手册 DS_AW8646G_EN_V1.0 英文   2023-06-06
产品设计指南 AW8646GQNR硬件设计指南 中文   2025-10-11

设计和开发

如需其他信息或资源,请查看下方列表,点击标题即可进入详情页面。