AW39204GQNR

4-Bit Bidirectional Voltage-Level Translator with Auto Direction
Sensing

产品手册：

在线预览 - AW39204GQNR - 产品手册

参考价格

1-99￥7.69
100-249￥6.31
250-499￥5.08
500-999￥4.00
1000+￥3.08

产品详细信息

参数

Data Rate (Max) (Mbps)	140
VCCA (Min) (V)	1.1
VCCA (Max) (V)	5
VCCB (Min) (V)	1.1
VCCB (Max) (V)	5
ICCA+ICCB (Max) (μA)	10
Channel	4
Support	Push-Pull
Temperature	-40℃~105℃
Transmission Direction	Auto
Package (mm)	QFN 2X1.7-12L

封装 | 引脚 | 尺寸

QFN 2X1.7-12L

特性

• Voltage level translator without direction control
signal
• Wide VCCA,VCCB operating range:1.1V to 5V
• VCCA and VCCB are independent: VCCA may be greater than, equal to, or less than VCCB
• 100 pF capacitance drive capability
• 140 Mbps date rate for VCCA and VCCB > 1.8 V
• VCC isolation feature – If either VCC input is at GND, all outputs are in High-Impedance state
• OE input circuit referenced to VCCA
• QFN 2.0mm×1.7mm×0.5mm-12L package

说明

AW39204GQNR is a 4-bit non-inverting bidirectional voltage-level translator, it can be used to convert digital signal with mixed-voltage systems. It needs two separate power supply rails, with the A ports supporting operating voltages from 1.1 V to 5 V while it tracks the VCCA supply, and the B ports supporting operating voltages from 1.1 V to 5 V while it tracks the VCCB supply. This allows the support of both lower and higher logic signal levels while providing bidirectional translation capabilities between any of the 1.2 V,1.8 V, 2.5 V, 3.3 V, and 5 V voltage nodes.
If the voltage level of output-enable (OE) pin is low, the chip works in the high-impedance state, which significantly reduces the power-supply quiescent current consumption. Ａｎｄ the OE input circuit is supplied by VCCA.
To ensure the high-impedance state during power up in power down, OE should be tied to GND through a pull-down resistor; the minimum value of the resistor is determined by the current-sourcing capability of the driver.

技术文档

类型	项目标题	语言	日期
产品手册	DS_AW39204GQNR_EN_V1.0	英文	2023-06-06
Checklist	CL_客户_项目_AW39204AQNR_AW39204GQNR_Customer_CN_V1.0	中文	2026-02-02
产品设计指南	AW39204X Hardware Design Guide	中文	2026-07-16

设计和开发

如需其他信息或资源，请查看下方列表，点击标题即可进入详情页面。

硬件开发

评估板

AW391X4 EVB V1.0 — AW39204PLR_EVB_1.0是适用于4通道电平转换芯片的评估板

AW39204PLR_EVB_1.0是适用于4通道电平转换芯片的评估板

了解详情

硬件开发

评估板

AW391X4 EVB V1.0 — AW39204PLR_EVB_1.0是适用于4通道电平转换芯片的评估板

AW39204PLR_EVB_1.0是适用于4通道电平转换芯片的评估板

了解详情